Advertisement
PackshotCreator R3 Mark II
COMPONENT REPL ACEMENT
LED LAMP REPLACEMENT:
01
Disconnect the two wires by
pressing the connector node while
pulling the wire out.
Note:
wire is V+ and the black wire is V-.
04
Use the same method to replace
the LED lamps on the bottom,
bottom corner, back and top light
panel.
02
Use a Phillips screwdriver and
gently remove the LED lamps.
The red
05
The LEDs in this system
Caution:
are made to last 38,000 hours.
Periodically check for and replace
any broken LED crystals,
otherwise it can cause others in
the same set to malfunction.
03
Use the same method to replace
the LED lamps on the corner.
Advertisement
