PackshotCreator R3 Mark II
CENTERING ARM (SOLD SEPARATELY)
01
Use a Phillips screwdriver to
remove the 4 black screws.
PackshotCreator R3 Mark II
COMPONENT REPL ACEMENT
CONTROL BOARD AND POWER SUPPLY:
01
To access the control boards,
unplug the studio then open the
bottom panels.
02
Attach the centering arm using 4
small black hand screws.
02
Open the bottom panel on the left,
right, and the back door.
03
Plug in the power cable.
03
To access the power supply,
unplug the studio then open
the back door and bottom
panel on the back of the unit.