Advertisement
PackshotCreator R3 Mark II
COMPONENT REPL ACEMENT
ACCESS THE BACK LAMP:
01
Remove 2 small white hand screws
and the holding bracket on the top
of the curved background.
ACCESS THE BOTTOM CORNER LAMP:
01
Loosen the 3 hand screws and
remove the side rails. Also remove
the 3 hand screws on the curved
guiding rails.
02
Lift to remove the curved
background from the system with
2 people at opposite sides.
02
Remove the end blocks using a
Phillips screwdriver.
03
When re-installing
Note:
the curved background, we
recommend to slide it down with
2 people at opposite sides. Use
one hand to brace and guide the
bottom corner into the curved rail
and then press it down until it flush
with the bottom background.
03
Carefully remove the bottom
glass plate and curved guiding
rails away from the system by
liing up and forward.
Note:
recommend 2 people one on each
side holding onto the bottom glass
and curved guiding rail.
We
Advertisement
