Saving Test Results To A Test Record - Vanguard Instruments Auto-Ohm 200 S3 User Manual

Auto-Ohm 200 S3 / DMOM-200 S3 / DMOM-600 USER'S MANUAL

3.5.2. Saving Test Results to a Test Record

After performing a test, the user is presented the option to save the test results to the unit's
Flash EEPROM or to a USB Flash Drive. If the test results are not saved immediately after
performing a test, they will still remain in the working memory and can be saved later, as long
as a new test has not been performed and the unit has not been turned off. Follow the steps
below to save the test results from the working memory to a test record (the following
procedure can also be used to re-save a restored test record to a new memory location or to a
USB Flash Drive):
a. Perform a test or restore a test record to the working memory (see section 3.5.3 and
3.5.4), and then start from the "START-UP" menu:





Press the key (SETUP).
[2]
b. The following screen will be displayed:
 
 
 
 
 


Press the key (SAVE/RESTORE RECORD)
[3]
c. The following screen will be displayed:
 
 
 
 
 


Option 5 (COPY TO THUMB DRIVE) will be listed only if a USB Flash drive is
connected to the Auto-Ohm.
NOTE
Press the key (SAVE RECORD).
[2]
REV 2
42