Table of Contents
Advertisement
3.7
Working With Test Records
3.7.1. Saving Test Results to a Test Record
After performing a test, the user is presented the option to save the test results to the unit's
Flash EEPROM or to a USB Flash Drive. If the test results are not saved immediately after
performing a test, they will still remain in the working memory and can be saved later, as long
as a new test has not been performed and the unit has not been turned off. Follow the steps
below to save the test results from the working memory to a test record (the following
procedure can also be used to re-save a restored test record to a new memory location or to a
USB Flash Drive):
a. Perform a test or restore a test record to the working memory (see section 3.7.2 and
3.7.3), and then start from the "START-UP" menu:
1. RUN TEST
2. SETUP
3. TEST PLANS
4. DIAGNOSTIC
TIME:
11:23:01
DATE:
09/09/14
[2]
Press the
key (SETUP).
b. The following screen will be displayed:
1. RECORD ID
2. TEST VOLTAGE
3. PRINT RECORD
4. SAVE/RESTORE RECORD
5. NEXT PAGE
[4]
Press the
key (SAVE/RESTORE RECORD).
c. The following screen will be displayed:
1. RESTORE RECORD
2. SAVE RECORD
3. RECORD DIRECTORY
4. ERASE RECORD
[2]
Press the
key (SAVE RECORD).
If a USB Flash drive is connected to the unit, continue to step d.
If a USB Flash drive is NOT connected to the unit, continue to step e.
TRF-250 USER'S MANUAL
REV 1
55
Advertisement
Table of Contents
