Related Manuals for Ingersoll-Rand 2705P1
Summary of Contents for Ingersoll-Rand 2705P1
- Page 1 P7540-EU Edition 1 July 2003 04578183-00 Impact Wrench Parts and Maintenance 2705P1...
-
Page 2: Maintenance
Lubrication Each time a Series 2705P1 Impactool is lightly with grease around the Hammer Case disassembled for maintenance and repair or Bushing (40). Inject approximately 1 to 2 cc replacement of parts, lubricate the tool as of grease into the Grease Fitting (2). -
Page 3: Disassembly Of The Motor
Disassembly of the Motor 1. Lift the Rear Hammer Frame Washer (36) and The twin hammers will be free to slide from the two Motor Clamp Washers (33) from the the Hammer Frame when the Hammer Pins front of the motor. are removed. -
Page 4: Assembly Of The Reverse Valve
Washer contacts the 1. 1. Coat the Hammers (37) with a light film Hammer Case Pilot (38A). of Ingersoll-Rand Impactool Grease No. 15.Place the Rear Hammer Frame Washer (36) 100. over the hub of the Rotor and against the 2. -
Page 5: Troubleshooting Guide
Anvil and against the Motor Housing. over the splined hub of the Rotor. 3. Install the Hammer Case Cap Screws (41). 2. Smear a thin film of Ingersoll-Rand Tighten the Hammer Case Cap Screws to 60 Impactool Grease No. 100 on the inside to 70 in-lb (6.8 to 7.9 Nm) torque. - Page 6 PXXX-3 Ed 1...
- Page 7 Anvil Assembly (with pin-type retainer) 231B-726 • 44 Socket Retaining Plunger 804-716 • 45 Plunger Spring 5UHD-718 Nameplate 2705P1-30l Tube of Grease 405-MG1 Lube Injector 230-228 Bottle of Oil 405-M01 Tune-up Kit (includes illustrated parts 4 (2), 6, 7, 13, 14, 23, 2705-TK3 24, 25, 29, 32, 39, 44, 45) and (non-illustrated part R1-75) * Not illustrated.
- Page 8 Ingersoll--Rand Company Ingersoll--Rand16 Pietro Camino de Rejas 1,2--18 B1SUl Stawki 2 28820 Coslada (Madrid)PL--00193 Warsaw EspañaPoland Tel: (34) 1 669 5850Tel: (48) 2 635 7245 Fax: (34) 1 669 6054Fax: (48) 2 635 7332 © Ingersoll-Rand Company, 2003 Printed in U.S.A.