Table of Contents
Advertisement
Assembly of the Impactool
1. Set the assembled impact mechanism down
over the splined hub of the Rotor.
2. Smear a thin film of Ingersoll-Rand
Impactool Grease No. 100 on the inside
Trouble
Low power
Motor will not run
Tool will not impact
Save these instructions. Do not destroy.
When the life of the tool has expired, it is
recommended that the tool be
disassembled, degreased and parts be
separated by material so that they can be
recycled.
PXXX-3 Ed 1
3. Install the Hammer Case Cap Screws (41).
Troubleshooting Guide
Probable Cause
Dirty Inlet Bushing or Air
Strainer Screen and/or Exhaust
Worn or broken Vanes
Worn or broken Cylinder and/or
scored End Plates.
Dirty motor parts.
Improper positioning of Reverse
Valve.
Incorrect assembly of motor.
Insufficient lubrication impact
mechanish.
Broken or worn impact
mechanism parts.
Impact mechanism assembled
incorrectly.
The use of other than genuine Ingersoll--
Rand replacement parts may result in safety
hazards, decreased tool performance, and
increased maintenance, and may invalidate
all warranties.
Repairs should be made only by authorized
trained personnel. Consult your nearest
Ingersoll--Rand Authorized Servicenter.
surface of the Hammer Case Bushing (40),
and place the Hammer Case down over the
Anvil and against the Motor Housing.
Tighten the Hammer Case Cap Screws to 60
to 70 in-lb (6.8 to 7.9 Nm) torque.
Using a suitable cleaning
solution in a well ventilated
area, clean Air Strainer Screen,
Inlet Bushing and Exhaust
Silencer.
Replace complete set of Vanes.
Examine Cylinder and replace it
if it is worn or broken or if bore
is scored or wavy. Replace End
Plates if they are scored.
Disassemblye the Tool and clean
in a suitable cleaning solution in
a well ventilated area.
Reassemble the tool as
instructed in this manual.
Make certain Reverse Valve is
fully engaged to left or right.
Disassemble motor, replace worn
or broken parts and reassemble
as instructed.
Remove Hammer Case Assembly
and lubricate impact mechanism.
Remove Hammer Case Assembly
and examine impact mechanism
parts. Replace any worn or
broken parts.
refer to Assemble of Impact
Mechanics.
Solution
5
Advertisement
Table of Contents
