•
Rotate the control lever (M2) downward until the pressing
plate (M7) arrives near the edge of the drum.
M2
Fig. 6M
•
Stop the descent of the hoist by turning the control lever
(M2) to the intermediate position.
M2
STOP
Fig. 7M
•
Center the drum (M5) correctly on the plate (M8) so that it is
aligned with the pressing plate (M7).
•
Lock the clamps (M6) to secure the drum (M5).
M4
M5
Fig. 8M
ED. 10 - 07/2020 - Cod. 150133
Pneumatic hoist twin mast for 200 litres
Fig. 9M
•
M7
Fig. 10M
•
The rod (M9) of the vent valve must not be completely
unscrewed.
M7
M4
M8
Fig. 11M
Grease the pressing plate gasket (M7) and the internal surface
of the drum.
Close the relief valve (M9) located on the pressing plate (M7).
NOTE
M9
M6
M7
www.larius.com
15