Transport And Storage - Bosch Rexroth CS351 Operating Instructions Manual

CS351/CC-CS351 | 3 609 929 B45/2019-12

Transport and storage

Hex coding switch
On networked systems (sibracks, system boxes
or compact systems), the valid address must be
set on the hex coding switch before
commissioning. For this purpose, the address is
determined on the internal bus.
This setting ensures a clear identification of each
tightening channel. Values from 0 - F (address 0 -
15) can be entered. After having entered the
address, you must reset or restart the system.
8
0
Fig. 21: Setting the address of the
Compact System
NOTE
Never enter two identical addresses (subrack,
system box or compact system) in the system
bus. The address of a system bus consumer
must always be unique.
XDAc2
address
Bosch Rexroth AG
5
Transport and storage
For storing and transporting the product always
observe the ambient conditions specified in the
technical data (see "Technical data" on page 88).
Make sure the Compact System is kept upright if
it is transported in the assembled state. If it is not
possible to keep it upright while transporting,
secure the Compact System accordingly.
73/96