Bosch Rexroth CS351 Operating Instructions Manual page 72

72/96 Bosch Rexroth AG
Product description
LED display
The network status is indicated by the three
LEDs on the front panel (see Fig. 20):
• LED 1 describes the network status of the
users connected to XDAC1,
• LED 2 describes the network condition of
the compact system
• LED 3 describes the network status of the
users connected to XDAC2,
Tab.17:
State
Power supply too low
Connection is being established/
reconfiguration
Communication with user(s) at XDAC1 established
Communication with user(s) at XDAC2 established
Internal communication established
Poor connection to user(s) at XDAC1
Poor connection to user(s) at XDAC2
User at XDAC1 is not activated or not available
User at XDAC2 is not activated or not available
Internal user(s) not activated
a)
The cause may be a cable fault. Check whether the maximum cable length has been kept
and replace the cable if necessary.
CS351/CC-CS351 | 3 609 929 B45/2019-12
Fig. 20:
LED 1
user(s)
at XDAC1
All three LEDs flashing red synchronously
Yellow flashing
light
Green
Red flashing
a)
light
a)
Off
XDAc1
LED 1
LED 2
LED 3
XDAc2
LEDs for network diagnosis
LED 2
Internal
user(s)
Yellow flashing
light
Green
Off
LED 3
user(s)
at XDAC2
Yellow flashing
light
Green
Red flashing
light
Off