General Safety Instructions - Bosch Rexroth CS351 Operating Instructions Manual

CS351/CC-CS351 | 3 609 929 B45/2019-12

General safety instructions

General safety
2
instructions
The Compact System has been manufactured
according to the accepted rules of current
technology. There is, however, still a danger of
personal injury or damage to equipment if the
following general safety instructions and the
warnings before the steps contained in these
instructions are not complied with.
• Read these instructions completely and
thoroughly before working with the Compact
System.
• Keep these instructions in a location where
they are accessible to all users at all times.
• Always include the operating instructions when
you pass the Compact System on to third
parties.
Intended use
The product described in this documentation is
part of the control and power electronics for
Rexroth tightening systems and is intended for the
industrial application of tightening processes
exclusively in conjunction with other products.
Only use the product with the corresponding
connecting cables. The product is intended for
industrial use, and not for domestic applications.
NOTE
The Compact System CS351/CC-CS351 is
not designed to be directly connected to the
public low-voltage power supply, it is only
intended for use in industrial environments
(emission class A).
Bosch Rexroth AG
Observe the operating conditions and
performance limits specified in the technical data.
Proper use includes having read and understood
these instructions, particularly chapter 2 "General
safety instructions".
Only use the Compact System CS351 in
conjunction with a Rexroth ErgoSpin/CC-
ErgoSpin hand-held nutrunner or tightening
spindles to tighten and loosen bolts and nuts. Only
use the Compact System CC-CS351 in conjunction
with a Rexroth CC-ErgoSpin hand-held nutrunner
or tightening spindles to tighten and loosen bolts
and nuts.
The integrated logic is not permitted for
safetycritical applications. Safetycritical
applications are all applications that may result in
personal injury or property damage.
Improper use
Any use of the Compact System other than that
described in the section
"Intended use" is considered improper.
Personnel qualification
Assembly, commissioning and operation,
disassembly, service (including maintenance
and care) require basic electrical and mechanical
skills and familiarity with the associated technical
concepts. In order to ensure operating safety,
these activities must therefore only be carried
out by appropriately qualified technical
personnel or an instructed person under the
direction and supervision of qualified personnel.
Qualified personnel are those who are able to
assess the tasks they are commissioned to
perform, identify possible risks and take the
appropriate safety measures due to their
professional training, knowledge, and experience
as well as their knowledge of the applicable
regulations. Qualified personnel must observe
the rules relevant to the subject area.
51/96