Bosch Rexroth CS351 Operating Instructions Manual page 54

54/96 Bosch Rexroth AG
General safety instructions
Only operate the Compact System in grounded
networks. Operation in nongrounded networks
(IT network) is not permitted, as clearance and
creepage distances in the system may be
overloaded.Here, protective grounding is the
permissible protective measure in accordance
with EN 50178. The input cable to the Compact
System must have a PE wire.
Ensure that there is potential equalization
between the workpiece and the tightening
spindle, as well as the carrier plate therefor, so
that potential equalization is ensured for all
system components.
Protect the system from short circuits in the
connector cables with a fuse provided by the
customer.
After switching the device off, wait 10 seconds
before turning it back on.
Observe the discharging time (at least 90
seconds after disconnecting the system from the
network) before working on the power supply
connections.
During cleaning
Cover all openings with appropriate protective
devices to prevent detergent from getting into
the system.
Never use solvents or aggressive detergents.
Only clean the product using a slightly damp,
lintfree cloth. Only use water to do this and, if
necessary, a mild detergent.
Do not use a highpressure cleaner for cleaning.
During maintenance and repair
Perform the prescribed maintenance work at
the intervals specified in the instruction manual.
Make sure that no lines, connectors or
components are disconnected while the system is
under pressure and energized. Protect the
system from being switched on again.
CS351/CC-CS351 | 3 609 929 B45/2019-12
Disposal
Dispose of the product in accordance with the
currently applicable national regulations in your
country.
Batteries must not be disposed in the general
waste; the end user is obliged by law to return
used batteries. Used batteries may contain
contaminants which might be harmful for the
environment or for your personal health if not
correctly stored or disposed of. However,
batteries also contain various valuable materials
and must be collected and recycled separately.
Our batteries can be returned after use either
• to commercial waste management companies
for used batteries
• to treatment facilities for used devices
according to the electric and electronic
devices act
• or free of charge at our distribution agencies or
the Murrhardt site
The symbol with the crossed out waste container
means that batteries must not be disposed of in
the general waste but collected and recycled
separately