Bosch Rexroth CS351 Operating Instructions Manual page 53

CS351/CC-CS351 | 3 609 929 B45/2019-12
General safety instructions
Adhere to the following instructions
General instructions
Observe the valid regulations for occupational
safety and environmental protection for the
country where the product is used and at the
workplace.
Only use Rexroth products that are in perfect
technical condition.
• Check the product for visible defects such as
cracks in the housing or missing screws or
seals.
Do not change or modify the Compact System
under any circumstances.
Only use the product within the performance
range indicated in the technical data.
Persons who assemble, operate, disassemble or
maintain Rexroth products must not do so while
under the influence of alcohol, other drugs or
pharmaceuticals that may affect their ability to
respond.
Do not expose the Compact System to
unacceptable mechanical loads under any
circumstances. Never use the product as a
handle or step. Do not place any objects on it.
Observe the local, systemspecific regulations
and requirements; proper use of tools, lifting, and
transport equipment; as well as the relevant
standards, provisions, and occupational safety
regulations.
During assembly
Make sure the system component in question is
depressurized and deenergized before
assembling the product or connecting or
disconnecting plugs. Protect the system from
being switched on.
Lay cables and lines in accordance with the
permissible bending radiuses so that they cannot
be damaged and no one can trip over them.
Bosch Rexroth AG
Before commissioning, make sure that all the
connection gaskets and plugs are installed
correctly to ensure that they are leakproof and
fluids and foreign bodies are prevented from
penetrating the product.
During commissioning
Let the product acclimate itself for several hours
before commissioning, otherwise condensation
may form in the housing. Condensation can
damage the compact system when it is switched
on.
Make sure that all electrical connections are
either assigned or covered. Commission the
product only if it is installed completely.
During operation
Only allow persons who are authorized by the
operator to access the system's direct
operating area. This also applies when the
system is not in operation.
In case of an emergency, fault or any other
anomalies, switch the system off and protect it
from being switched on again.
DANGER
Inadequate emergency OFF equipment!
Danger to life through electrical or
mechanical forces
The user is responsible for determining the

need for an emergency OFF system, its
implementation, and the risk analysis
therefor! Make sure the emergency OFF
equipment is accessible and effective.
Releasing the emergency OFF equipment
must not result in an uncontrolled system
restart!
Check the function of the emergency OFF

equipment before switching the system on.
53/96