Table of Contents
Advertisement
EN
Safety Precautions
Be sure to read these Safety Precautions carefully prior to installation, and always be sure to follow the safety warnings and instructions.
This symbol indicates misuse may result in death or
serious injury.
WARNING
Examples of symbols
The symbol indicates a prohibited use of the product.
This product is classifi ed as Class 1 Equipment and must be grounded.
Install this equipment where the electrical outlet is accessible.
Use the new hose set included with this equipment. Do not reuse an old hose set.
*1
USA/Canada
AC120V
60Hz
Do not use this product with any power supply other than the one specified. (*1)
(Doing so may result in heat or fi re.)
Do not use a damaged power plug, damaged power cord or loose socket outlet.
(Doing so may result in electrical shock or fi re.)
Do not install an outlet directly beneath a water supply location. Do not allow the water supply hose to touch
the electrical outlet of plug.
(Condensation may seep into the outlet, resulting in fi re or electrical shock.)
Do not use any water other than tap or potable well water (underground water). Do not use seawater.
(Doing so may result in skin infl ammation or other ailments.)
Do not install the product on moving vehicles such as boats or RV's.
Prohibited
(Doing so could cause a fi re, electric shock, a short circuit, or other malfunctions. The toilet seat, lid, product main
body or other part might come loose and fall off, resulting in injury.)
Do not do anything that could damage the power cord, power plug.
Do not strike, yank, twist, excessively bend, damage, alter, or heat any electrical cords. Also, do not place anything
heavy on, bind or pinch them.
(Using a damaged electrical cord may result in a fi re, electrical shock, heat or a short circuit.)
Do not exceed the rated capacity of your electrical outlets or wiring equipment.
(Using a single outlet to supply power to many devices by using an extension cord or other adapters may result in fi re from excess heat.)
Be sure to plug the electrical cord all the way into the wall socket.
(Failure to do so may result in electrical shock or fi re.)
Always use a grounded (3-prong) electrical outlet and that is connected to a ground fault circuit interrupter (30mA or less).
[China, Korea, Taiwan, Asia, Oceania, Middle East]
Make sure to waterproof the power plug by using a silicon rubber sealant.
(A power plug that has not been waterproofed may cause fi re or electric shock.)
*If the power plug is not waterproof, ask the installer to waterproof it.
To unplug, hold the plug, not the cord.
Do not unplug by pulling the cord.
(Pulling on the cord may cause damage and result in fi re or heat.)
This is an electrical product. Do not locate it anywhere water is likely to get on it. Do not locate the product in a humid
environment where water may form on the surface of the product. When using the product in a bathroom,
install a ventilation fan or opening, so that the bathroom has suffi cient airfl ow to avoid extreme humidity.
(Failure to do so may result in electrical shock or fi re.)
Do not directly strike the porcelain section. This could break the porcelain section, causing injury,
material damage or a water leak.
When carrying this product by itself, always hold it by the porcelain section. Carrying it by holding any other
Required
section could break the product, causing injury, material damage or a water leak.
If the electric cord is damaged, avoid danger by having the manufacturer's repair department or equivalent
specialist replace it.
Always connect the product to the cold water supply.
(Connecting to hot water supply may result in burns and equipment damage.)
When installing this product, comply with the regional codes and standards on installation work.
Check that the product is electrically grounded appropriately.
(If a ground is not installed, a breakdown or electrical current leak may result in electrical shock.)
[China]
For a ground, use copper wire with a ground resistance of 100Ω max. and a diameter of 1.5 mm min.
[Korea, Asia, Oceania, Middle East]
For a ground, use copper wire with a ground resistance of 100Ω max. and a diameter of 1.6 mm min.
*If there is no ground installed, ask the installer to put in a ground.
2
CAUTION
China
Korea
AC220V
AC220V
50Hz
60Hz
WARNING
This symbol indicates misuse may result in injury or
physical damage.
The symbol is used to indicate a required step in the
use of this product.
Taiwan
AC110V
60Hz
Asia/Oceania/
Middle East
AC220-240V
50Hz / 60Hz
Hide quick links:
Advertisement
Table of Contents
