Precautions Before Installation / Précautions Avant L'installation / Precauciones Antes De La Instalación - Toto WASHLET Installation Manual

Precautions before installation / Précautions avant l'installation / Precauciones antes de la instalación
EN
zTurn on the electricity and water supply for the product only after all other installation work is complete.
zDo not damage the connection components on the water supply hose (C-5).
zThe water supply pressure ranges from 7.25 PSI (0.05 MPa) <dynamic> - 108.75 PSI (0.75 MPa) <static>.
Use the unit within the said pressure range.
zThe temperature of the water supply should be within a range of 32-95 °F (0 to 35 °C). Make sure the temperature is within this range.
zWorking ambient temperature is within the range of 32-104 °F (0 to 40 °C). Make sure the temperature is within this range.
zDo not use water supply hoses (C-5) and junction valve (A-7) other than those supplied with the product.
* Because a water flow test is conducted on each product at the factory, water may remain inside the product.
This water does not indicate a problem with the product.
zCheck that the product is electrically grounded appropriately. (If a ground is not installed, a breakdown or electrical
current leak may result in electrical shock.)
zPrepare an outlet position in advance that conforms to the regulations in your country.
zPerform wiring correctly according to this product's specifications (rated power 15 A or more, 120 V AC (60 Hz)).
*Power supply, rated power consumption is indicated on the label of this product.
zThe power cord is 3.9 ft (1.2 m) long.
Check that the outlet is provided in a location appropriate for this length.
Check the position of the hole in the toilet bowl through which the water supply hose (C-5)
Attention!
and power cord (C-2) pass.
The additional part
(sold separately) is
not required.
Follow the procedure to
install the product.
The additional parts (sold separately) is recommended.
■Cover assembly (part number: THU6452)
To purchase the part, contact TOTO Tech Services.
(888)295-8134 option 4
* Please note that the specifications, part number, etc. are subject to change without
prior notice.
This part changes the way the water supply hose (C-5) and power
cord (C-2) are routed and hides the hole in the toilet bowl that is
visible from the rear of the product.
For information about how to change routing and how to attach the
part, refer to the installation manual included with the cover assembly.
Hole in the toilet bowl
5
Cover assembly
(Part number: THU6452)