Advertisement
EN
Safety Precautions
Be sure to carefully read this "Safety Precautions" document before beginning installation.
Please comply with all safety warnings and precautions.
Symbols and Meanings
This symbol indicates misuse
WARNING
may result in death or serious
injury.
Examples of symbols
The symbol indicates a prohibited use of the
product.
lThis product is classified as Class I Equipment and must be grounded.
lInstall this equipment where the electrical outlet is accessible.
lUse the new hose set included with this equipment. Do not reuse an old hose set.
Do not use this product with any power supply other than the one specified. (AC 220-240 V,
50 Hz/60 Hz)
Ÿ Doing so may result in heat or fire.
Do not use a damaged power plug, damaged power cord or loose socket outlet.
Ÿ Doing so may result in electrical shock or fire.
Do not install an outlet directly beneath a water supply location. Do not allow the water supply
hose to touch the electrical outlet of plug.
Ÿ Condensation may seep into the outlet, resulting in fire or electrical shock.
Do not use other water then allowed by the laws and ordinances of the region of use.
Only use drinking water. Do not use seawater or recycled water.
Ÿ Doing so may cause irritation to the skin and malfunction.
Do not install the product on moving vehicles such as boats or RV's.
Ÿ Doing so could cause a fire, electric shock, a short circuit, or other malfunctions.
Ÿ The toilet seat, lid, product main body or other part might come loose and fall off, resulting in injury.
Do not do anything that could damage the power cord, power plug.
Do not strike, yank, twist, excessively bend, damage, alter, or heat any power cords. Also, do not place
anything heavy on, bind or pinch them.
Ÿ Using a damaged power cord may result in a fire, electrical shock, heat or a short circuit.
Do not exceed the rated capacity of your electrical outlets or wiring equipment.
Ÿ Using a single outlet to supply power to many devices by using an extension cord or other adapters
may result in fire from excess heat.
Be sure to plug the power cord all the way into the wall socket.
Ÿ Failure to do so may result in electrical shock or fire.
To unplug, hold the power plug, not the power cord.
Do not unplug by pulling the power cord.
Ÿ Pulling on the power cord may cause damage and result in fire or heat.
Make sure to waterproof the power plug by using a silicon rubber sealant.
Ÿ A power plug that has not been waterproofed may cause fire or electric shock.
*If the power plug is not waterproof, ask the installer to waterproof it.
This is an electrical product. Do not locate it anywhere water is likely to get on it. Do not locate
the product in a humid environment where water may form on the surface of the product.
When using the product in a bathroom, install a ventilation fan or opening, so that the bathroom
has sufficient airflow to avoid extreme humidity.
Ÿ Failure to do so may result in electrical shock or fire.
Always connect the product to the cold water supply.
Ÿ Connecting to hot water supply may result in burns and equipment damage.
This symbol indicates misuse
CAUTION
may result in injury or physical
damage
The symbol is used to indicate a required
step in the use of this product.
WARNING
2
EN
Safety Precautions (Continued)
Check that the product is electrically grounded appropriately.
For a ground, use copper wire with a ground resistance of 100 Ω max. and a diameter of 1.6 mm min.
Ÿ If a ground is not installed, a breakdown or electrical current leak may result in electrical shock.
*If there is no ground installed, ask the installer to put in a ground.
Confirm that wiring is connected correctly (L terminal: Live, N terminal: Neutral).
Ÿ Incorrect wiring may cause mechanical failure.
Always use a grounded (3-prong) electrical outlet and that is connected to a ground fault circuit
interrupter (30mA or less).
If the power cord is damaged, avoid danger by having the manufacturer's repair department or
equivalent specialist replace it.
When installing this product, comply with the regional codes and standards on installation work.
All-pole disconnection incorporated in the fixed wiring shall be provided.
Do not lift the product by the toilet seat or toilet lid.
Ÿ Doing so may result in the product main body dislodging, falling and causing injury.
Do not fold or crush the water supply hose; do not damage by cutting with a sharp object.
Ÿ Doing so may result in water leakage.
Do not remove the water filter drain valve while the shutoff valve is open.
Ÿ Doing so will result in water leakage.
Install the Washlet properly according to the Installation Guide.
Ÿ Improper installation may result in water leakage, electric shock or fire.
Push the product main body securely onto the base plate.
After pushing the product main body until a click sound is heard, pull it slightly toward you to
make sure that the product does not detach.
Ÿ Not doing so may result in the product main body dislodging, falling and causing injury.
Precautions before installation
lDo not turn on the electricity and water supply for the product until installation work is complete.
lDo not damage the connection components on the water supply hose (C-5).
lThe water supply pressure ranges from 0.05 MPa <dynamic> - 0.75 MPa <static>.
Use the unit within the said pressure range.
lThe temperature of the water supply should be within a range of 0 to 35 °C. Make sure the temperature is within this
range.
lWorking ambient temperature is within the range of 0 to 40 °C. Make sure the temperature is within this range.
lDo not use water supply hoses (C-5) and junction valve (A-2) other than those supplied with the product.
* Because a water flow test is conducted on each product at the factory, water may remain inside the product. This
water does not indicate a problem with the product.
lPerform wiring correctly according to this product's specifications (220-240 V AC (50 Hz/60 Hz)).
*Power supply, rated power consumption is indicated on the label of this product.
lThe power cord is 1.2 m long.
Check that the outlet is provided in a location appropriate for this length.
WARNING
CAUTION
3
Advertisement
