Table of Contents
Advertisement
VIPA System SLIO
Exchange of a module
group
HB300 | FM | 050-1BB30 | en | 20-40
9.
Plug again the electronic module, which you have removed before.
10.
Wire your module.
ð Now you can bring your system back into operation.
1.
Power-off your system.
2.
Remove if exists the wiring of the module group.
3.
For demounting and exchange of a (head) module or a group of
modules, due to mounting reasons you always have to remove the
electronic module right beside. After mounting it may be plugged
again.
Press the unlocking lever at the lower side of the just mounted right module near
the module group and pull it forward.
4.
Turn all the locking lever of the module group to be exchanged upwards.
5.
Pull the module group forward.
6.
For mounting turn all the locking lever of the module group to be mounted upwards.
7.
To mount the module group put it to the gap between the both modules and push it,
guided by the stripes at both sides, to the mounting rail.
8.
Turn all the locking lever downward, again.
Basics and mounting
Demounting 8x periphery modules
31
Advertisement
Table of Contents
