Table of Contents
Advertisement
VIPA System SLIO
Mounting periphery
modules
HB300 | FM | 050-1BB30 | en | 20-40
1.
Mount the mounting rail! Please consider that a clearance from the middle of the
mounting rail of at least 80mm above and 60mm below, respectively 80mm by
deployment of shield bus carriers, exist.
2.
Mount your head module such as CPU or field bus coupler.
3.
Before mounting the periphery modules you have to remove the bus cover at the
right side of the head module by pulling it forward. Keep the cover for later
mounting.
4.
For mounting turn the locking lever of the module upwards until it engages.
5.
For mounting place the module to the module installed before and push the module
to the mounting rail guided by the strips at the upper and lower side of the module.
6.
Turn the locking lever of the periphery module downward, again.
Basics and mounting
Mounting 8x periphery modules
19
Advertisement
Table of Contents
