Table of Contents
Advertisement
VIPA System SLIO
Electronic unit and ter-
minal block
2
Mounting periphery
module
HB300 | FM | 050-1BB30 | en | 20-40
Each 16x periphery module consists of an electronic unit and a terminal block.
1
Electronic unit
2
Terminal block
To replace an electronic unit, you can push down and pull off the terminal block after
1
releasing the lock. To mount the terminal block, place it horizontally on the lower side of
the electronic unit and push it towards the electronic unit until it clicks into place.
1
2
1.
Mount the mounting rail! Please consider that a clearance from the middle of the
mounting rail of at least 80mm above and 80mm below exist.
2.
Mount your head module such as CPU or field bus coupler.
3.
Before mounting the periphery modules you have to remove the bus cover at the
right side of the head module by pulling it forward. Keep the cover for later
mounting.
Basics and mounting
Mounting 16x periphery modules
Clack
21
Advertisement
Table of Contents
