Step 4. Connect 802.3af/802.3at PoE Device
802.3af/at PoE Device
1. Connect the PoE devices to ports 1~ 4 on the BSP-360.
2. Check the PoE-in-Use LED. If the network devices such as PoE camera and PoE
wireless AP are powered, the PoE-in-use LED will turn ON and Link/Act LED
will blink for a successful connection or data receiving.
Please use Cat5/5e or above cable and the maximum distance
should within 100 meters.
If the Network devices are installed outdoors, please consider
to install a well-grounded lightning arrestor (such as PLANET
Note
ELA-100) to protect the network device and the BSP-360.
PoE
PoE
PoE
PoE
1
Surge arrester is required
and
Equipment must
must be grounded
be grounded
Caution
The proper antenna must
2
connected before powering
be
PoE In: 802.3at PoE
the AP on
Don't turn "A" when
A
B
attaching "B"
13