Hardware Introduction; Front Panel - Planet Networking & Communication BSP-360 Quick Installation Manual

3. Hardware Introduction

3.1 Front Panel

The front panel of the BSP-360 consists of 5 auto-sensing 10/100/1000Mbps
Ethernet RJ45 ports and one USB interface. The LED Indicators are also located on
the RJ45 ports of the BSP-360.
Item Interface
1 Port-1~Port-4
2 Port-5
3 USB
4 Reset Button
4-pin Terminal
5
Block
6
PWR Fault PV System
50W 100W 120W
PoE Power
Usage
1
2
1
3
4
3
5/WAN
LNK ACT
PoE-in-Use
4
Reset
V1+
V2+
5
DC Ouput: 24V , 1A max.
Figure 3-1 shows the front panel of BSP-360
4 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports with
802.af/at PoE+ injector function.
One 10/100/1000BASE-T RJ45 auto-MDI/MDI-X port.
Port-5 functions as WAN port when the operation
mode of BSP-360 is configured to "Gateway mode".
Connect the USB storage to USB port and back up the
configuration file.
< 5 seconds: System reboot.
> 5 seconds: Factory default.
2 x 24V 1A DC output connector.
The output voltage is the same as battery voltage.
Maximum power output is clamped at 24W.
2
BSP-360
Description