Device Configuration And Control; Adding Centrally Located Devices - AMX Endeleo UDM-1604 Operation/Reference Manual

Device Configuration and Control

The system allows "centrally located" devices connected to the rear of the UDM Hub e.g. VCR, DVD,
DVR or Satellite Decoders to be managed from the user port. This is performed through the Devices
page.
FIG. 30
UDM-1604 rear panel - IR TX ports
"Centrally Located "means the device is connected directly to the rear of the UDM
hub via the UDM IR ports (Tx1 – Tx4) using an Endeleo IR Tx bud.
The IR Tx bud will then transmit the IR signal from the UDM hub to the device.
An Endeleo IR splitter will be needed for each of the IR ports if using 2 devices per IR port.

Adding Centrally Located Devices

1. Select the Devices option from the options to the left of the screen (FIG. 31).
FIG. 31 Devices screen
2. Name the Device accordingly e.g. DVD Rack2.
Ensure the correct port is selected. Device 1 refers to IR TX1 at the rear of the UDM
Hub, Device 4 refers to IR TX4 at the rear of the UDM hub.
3. Configure the Device with the relevant IR protocol if appropriate.
Refer to the Protocols and IR Learning section on page 31 for details on creating or learning IR
protocols.
4. Configure the Device with the correct Associated Input (i.e. where the Device, as an Input type, is
physically cabled to on the Hub);
UDM-1604 Endeleo Multi-Format Distribution Hub
If only one device connected to IR TX port 1/2 it will by default be Device 1.
If only one device connected to IR TX port 3/4 it will by default be Device 3.
If the Device is connected to an input at the rear of the Hub select the relevant associated input
(A-D).
If the Device is connected to a TVM-AV input at the front of the UDM Hub select the relevant
TVM-AV (1-4) associated input.
Device Configuration and Control
29