Safety Procedures Using Wheel Loader - probst JUMBO-BV-VARIO Manual

Safety
JUMBO-BV-VARIO-B
V2

4.18 Safety procedures using wheel loader

●
To prevent any injury and to reduce
noise always close the silencer hood.
●
Never set the wheel loader onto the
forks.
●
Prohibition
Never move the wheel loader with a
kerb stone sucked up
●
Move the wheel loader only,
- when the lifting unit is fixed with a
chain,
- when the boom is secured with socket
Attention
pin against swing about.
●
While using device Jumbo BV, be sure
that there are no person in the working
area. It is strictly forbidden to stay under
hanging goods.
LIFE DANGER !!!
Danger
●
The driver of the wheel loader have to
stay on his seat as long as the Jumbo BV
vario-b is carrying goods. and must
Prohibition
always be able to see the load.
●
It is not allowed to put or drag kerb
stones diagonally.
Prohibition
●
Avoid quick or jerky movements with
the device Jumbo BV vario-b.
●
Do not use the device to jerk seized
Prohibition
products.
●
Only start the compressor, when the
lever is on position „lower" and the
suction plate is not positioned over
Danger
load.
●
Never release the control lever, as long
as a kerb stone is lifted.
Danger
●
Switch off the vacuum blower with each
work stoppage and deposit the kerb
stone on the ground. Never make a
work stoppage with lifted kerb stone,
Danger
danger of overheating of the gear unit.
●
If the compressor should fail, switch the
operating lever immediately to position
„lift". The remaining vacuum will ensure
Danger
that the load will not fall down.
26/07/16
18 / 40