Wall Mounting Instructions - Nexcom NDiS B533 User Manual

Chapter 3: System Setup

Wall Mounting Instructions

To mount the system on to a wall or some other surface using the two
mounting brackets, please follow the steps below.
1. Turn the system over, then remove the two screws.
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
2. Align the two retention screw holes in each bracket with the retention
screw holes on the sides of the bottom surface. Secure the brackets to
the system by inserting two retention screws into each bracket.
Specification of the wall mount screw:
Round Head Screw w/Spring+Flat Washer Long Fei
6#32*min. 5.7mm-8mm_w/Spring+Flat
3. Drill holes in the intended installation surface.
4. Align the mounting holes on the sides of the mounting brackets with the
predrilled holes on the mounting surface.
5. Insert four retention screws, two in each bracket, to secure the system
to the wall.
35
Wall Mount Bracket
NDiS B533 User Manual