Nexcom NDiS B533 User Manual page 59

Chapter 4: BIOS Setup
Graphics Configuration
This section is used to configure the graphics parameters.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Main Advanced Boot Security
Primary IGFX Boot Display [HDMI1]
Secondary IGFX Boot Display [HDMI2]
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Primary IGFX Boot Display
Select the Video Device which will be activated during POST. This has no
effect if external graphics present. Secondary boot display selection will
appear based on your selection. VGA modes will be supported only on
primary display. The options are VBIOS Default, HDM1, HDMI2 and HDMI3.
Secondary IGFX Boot Display
Select the secondary display device, the options are Disabled, HDMI1,
HDMI2 and HDMI3.
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
Save & Exit
Select the Video Device which
will be activated during POST.
This has no effect if external
graphics present.
Secondary boot display selection
will appear based on your
selection.
VGA modes will be supported
only on primary display
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
AMT Configuration
This section is used to configure Active Management Technology (AMT)
options.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Main Advanced Boot
Intel AMT
BIOS Hotkey Pressed
MEBx Selection Screen
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Intel AMT
®
Enables or disables Intel Active Management Technology.
®
BIOS Hotkey Pressed
Enables or disables BIOS hotkey press.
MEBx Selection Screen
Enables or disables MEBx selection screen.
45
Security Save & Exit
[Enabled] Enable/Disable Intel (R) Active
Management Technology BIOS
[Disabled]
Extension.
[Disabled]
Note : iAMT H/W is always
enabled.
This option just controls the
BIOS extension execution.
If enabled, this requires
additional firmware in the SPI
device
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
NDiS B533 User Manual