Nexcom NDiS B533 User Manual page 57

Chapter 4: BIOS Setup
SATA Configuration
This section is used to configure the SATA drives.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Main Advanced Boot Security
SATA Controller(s) [Enabled]
SATA Mode Selection [AHCI]
Serial ATA Port 0 Empty
Software Preserve Unknown
Port 0 [Enabled]
Spin Up Device [Disabled]
Serial ATA Port 1 Empty
Software Preserve Unknown
Port 1 [Enabled]
Spin Up Device [Disabled]
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
SATA Controller(s)
Enables or disables the SATA controller.
SATA Mode Selection
Configures the SATA as IDE or AHCI mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
Save & Exit
Enable or disable SATA Device.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Port 0 and Port 1
Enables or disables Serial ATA port 0 to port 2.
Spin Up Device
Enables or disables staggered spin up on devices connected to Serial ATA
port 0 to port 2.
43
NDiS B533 User Manual