Linak Desk Frame 1 Assembly Manual page 15

12.
Leveling Your Desk
13.1
Hold DOWN on the desk switch until the desk reaches its lowest point. (If system does not
lower, continue to next step)
13.2
Release desk switch and press DOWN again. Hold for 5 seconds while the system initializes. If
no movement, release and try again.
13.3
Desk should run down into an end stop, then automatically runs approximately 5mm out again.
Release desk switch.
13.4
Hold UP on the desk switch and raise the desk to its full height. Be sure the mains cable can
move freely.
13.5
Hold DOWN to complete a cycle of the desk. Your initialization is now complete and your desk is
ready to use.
13.
Initializing Your Desk
15