Table of Contents
Advertisement
Fig. 45
Fig. 46
Fig. 47
Make sure all labels are attached
•
Visually check the hand control and cable for
damage
•
Perform a full functionality test on Sara Flex
•
•
•
•
•
•
Check operation of the Emergency Stop/
Power Button and the Emergency Lowering
Handle
•
•
•
A
31
Check if all labels are attached on the Sara
Flex according to "Labels on Sara Flex" on
page 36.
Check the hand control screen for dead pixels
or any other display defects.
Raise the lifting arm to its highest position
using the hand control or the control panel.
Lower the lifting arm to its lowest position
using the hand control or the control panel.
Test every button on the hand control and the
control panel. (See Fig. 45)
All buttons must be working according to
"Controls and Features" on page 9.
Move the Sara Flex around on a at surface and
make sure that the four castors are in contact
with the ground.
Make sure to test the brakes. Activate the brakes
and try to move the Sara Flex around.
Check for abnormal sounds during movements.
Raise the lifting arm.
Push the lifting arm down while pulling up the
Emergency Lowering handle. The lifting arm
should lower slowly. (See Fig. 46)
While raising/lowering the lifting arm or
opening/closing the legs, press the Emergency
Stop/Power Button (A). The lift movement
should stop immediately. (See Fig. 47)
Advertisement
Table of Contents
