Wall Mounting Using An Arm Extension - American Dynamics SpeedDome Ultra Installation And Service Manual

Wall Mounting Using an
Arm Extension
This procedure explains how to mount the dome to
a wall using an arm extension. After completing
this procedure, go to page 2-17 for dome setup
and attachment procedures.
Ensure the wall material, particularly
sheet rock, can support the dome.
Tools Required
Level
Phillips head screwdriver
Drill with 1/4" concrete bit
Ratchet wrench with 5.5mm and 11mm sockets.
Mounting Structure Required
01RHIULWM Wall Mount, Extended
a. Bracket, wall mount
b. Arm, wall mount
c. Cap, pendent
d. Screw, machine, M4x10, PHP
e. Nut, locking, M3, SS
f. Anchor bolt, 1/4x2.25 w/Hdwr
g. Anchor, plastic
h. Washer, flat, LOD, M4
i. Screw, STAP, AB, 4.2x32, PHP
Figure 2-11. Wall mounting using an arm extension
f
g
1 0500-7485-01
1 0500-7488-01
1 0500-7719-01
2 5801-2061-120
2 5826-0200-020
3 2880-0011
3 2880-0073-01
3 5842-0300-020
3 5810-4091-120
a
d
h
i
SPEEDDOME ULTRA
INDOOR DOME INSTALLATION
Procedure
Referring to Figure 2-11:
1. Cut arm [b] to length and slip cap [c] over it.
2. Insert the arm into mounting bracket [a] and
secure using two M4x10 screws [d].
3. Place arm assembly on wall, level, and mark
locations for three mounting holes.
4. Anchor by performing step 2a, 2b, or 2c.
a. To sheet rock: Use anchor [g], washer [h], and
screw [i].
b. To wood: Use washer [h], and screw [i].
c. To concrete: Use anchor hardware [f].
5. Attach the base or top hat housing by per-
forming step 5a or 5b.
a. Direct base attachment. Attach the dome's base
to the studs on the flange of the arm using two
M3 locking nuts [e]. Feed cables as shown.
b. Top hat housing attachment. See "Top Hat Hous-
ing", page 2-5.
6. Go to "Dome Setup and Attachment", page
2-17.
b
e
2-12
c
Base