Mounting The Camera - American Dynamics Illustra Flex Series Quick Start Manual

2.2.4 Mounting the camera

Place the mounting template sticker (supplied) on the mounting surface and mark three holes according to
the mounting template sticker. Then fasten the anchors to the mounting surface with screws. Next, secure the
unit bottom case (1) to the wall/ceiling with tapping screws as supplied and adjust the view angle (zoom,
focus, and horizontal rotation).
Refer to figure 2-5. Connect the Safety Wire (Fall Prevention Wire, not supplied) with one end to the
wall/ceiling and the other to the safety-cord screw of the unit.
Warning Depending on the material of mounting surface, different screws and anchors than those
supplied may be required. To prevent the unit from falling off, ensure that it is mounted to a
firm place (ceiling slab or channel) using a safety wire strong enough to withstand the total
weight of the unit. (Pay also attention to the finishing at the end of the wire.)
Caution Safety wire must be connected with one end to the wall/ceiling and the other to the
safety-cord screw of the unit.
F 2-4: M
IGURE OUNTING THE
F 2-5: M
IGURE OUNTING THE
12
Illustra Flex 1MP & 3MP Outdoor Dome
C
AMERA
Safety wire (not supplied).
Please tighten on a firm place as shown.
C
AMERA