Installation; Mounting The Housing - American Dynamics SpeedDome RHODULP-01 Installation And Service Manual

Installation

Note: This section assumes cables are routed to
the mounting site.
Tools Required:
- .100in flat head screwdriver
- Phillips-head torque screwdriver
- 7/16in socket
- Nitrogen tank kit RHONKIT or equivalent
99.998% N .
2

Mounting the Housing

1. Carefully remove the housing from the package.
Ensure all parts are present.
Note: The standard model is a pendant mount
housing. A 1.5in NPT housing coupling is
provided for use with a standard 1.5in (NPT)
pipe.
2. Install pendant pipe mount or wall mount
bracket in the desired location.
Ensure the mount is properly secured
to a supporting structure capable of
rigidly holding the weight of the
housing once assembled.
3. Remove cover from pipe threads and ensure
threads are clean and rust free.
4. Loosen three set screws and detach the
bayonet coupling from the housing.
Bayonet
Coupling
Housing
5. Apply pipe sealing tape to the pipe threads and
thread the bayonet onto the mount.
SPEEDDOME ULTRA PRESSURIZED OUTDOOR DOME HOUSING
INSTALLATION AND SERVICE GUIDE
Set Screws
Apply pipe sealing
tape here.
3 of 10
6. Loop the safety cable exiting the top of the
housing over one of the set screws on the
bayonet coupling and connect cables exiting
housing and pipe together using the two screw-
down connectors supplied.
Safety
Cable
Power
1 Camera Power (24Vac)
2 Camera Power
(earth ground)
3 Camera Power (24Vac)
Data
1 RS-422 Rx+ (SensorNet)
2 RS-422 Rx– (SensorNet)
3 RS-422 Tx+
4 RS-422 Tx–
5 SensorNet
6 SensorNet
Note: The I/O circuit board wiring factory set up is
for RS-422. For SensorNet (or Manchester)
installations, disconnect orange and green wires
from P1-1 and P1-2 respectively, and reconnect
these wires to P1-5 and P1-6.
7. Reattach the housing to the bayonet and secure
the three captive screws.
CAUTION: Do not over tighten
screws. Tighten them only to the point
at which the gap closes between the
ring and the housing top.
Connectors
White
Red
Black
Orange
Green
Yellow
Brown
(See Note)
(See Note)
8200-0462-01, REV. B