Tile Ceiling Surface Mounting - American Dynamics SpeedDome Ultra Installation And Service Manual

Tile Ceiling Surface Mounting

This procedure explains how to mount the dome's
base directly to the T-bar intersection of a tile
ceiling. After completing this procedure, go to page
2-17 for dome setup and attachment procedures.
Install Kit Supplied
0351-1109-01*
a. Clip, T-bar
b. Screw, PH, M3X-8, PHP, SS
* Only parts used in this procedure are listed.
Procedure
1. Using screws [b], attach two dome mount-
ing clips [a] to the base (Figure 2-4).
Pivot screws are circled; they allow the brackets to
be maneuvered over the flange of the ceiling T-bar.
The other screws secure the base to the T-bar.
2. Maneuver the brackets over the horizontal
flange of the T-bar (Figure 2-5). Tighten all
screws to secure the clips to the T-bar.
3. Via the large hole in the base, punch a hole
in the ceiling tile for cable access.
4. Feed cables through the base, then go to
"Dome Setup and Attachment", page 2-17.
2 0500-7193-01
6 5801-1051-120
SPEEDDOME ULTRA
2-4
INDOOR DOME INSTALLATION
Figure 2-4. Mounting clip attachment
a
b
Figure 2-5. Base attachment to tile ceiling T-bar
intersection