Using The Adcim6Wallxk Wall Mount - American Dynamics Illustra 625PTZ Quick Reference Manual

Using the ADCiM6WALLxK Wall Mount

The following describes the process for installation of the i625PTZ surface mounting base to the
ADCiM6WALLxK Wall Mount.
Note
This guide assumes that the ADCiM6WALLxK Wall Mount has been installed using the installation
guide provided with the product and that cables have been pulled to the site.
Step Action
1 Remove the surface mounting base from the dome.
Refer to Installing the Surface Mounting Base step 3.
2 Remove the 4 x 8mm Hex Standoffs from the supplied kit.
3 Insert the 4 x 8mm Hex standoffs as seen in Figure 8.
4 Using the 4 x M4x6 screws Attach the Surface Mounting Base to the mounting as
illustrated. Sequentially tighten the screws to secure the base.
Note
Ensure that the bayonet cap lock is facing to the front of the mount as illustrated.
Figure 8
English illustra 625PTZ Dome
9