Wall Mounting Using A Corner Bracket And An Arm Extension - American Dynamics SpeedDome Ultra Installation And Service Manual

Wall Mounting Using a Corner
Bracket and an Arm Extension
This procedure explains how to mount the dome to
a wall using a corner bracket and an arm exten-
sion. After completing this procedure, go to page 2-
17 for dome setup and attachment procedures.
Ensure the wall material, particularly
sheet rock, can support the dome.
Tools Required
Level
Phillips head screwdriver
Drill with 1/4" concrete bit
Ratchet wrench with 5.5mm and 11mm sockets.
Mounting Structures Required
01RHIUCM Corner Mount
a. Bracket, corner
b. Label, prox. antenna
c. Screw, machine, M5x8
01RHIULWM Wall Mount, Extended
d. Bracket, wall mount
e. Arm, wall mount
f. Cap, pendent
g. Screw, machine, M4x10, PHP
h. Nut, locking, M3, SS
i. Anchor bolt, 1/4x2.25 w/Hdwr
j. Anchor, plastic
k. Washer, flat, LOD, M4
l. Screw, STAP, AB, 4.2x32, PHP
Figure 2-12. Wall mounting using corner bracket and arm extension
j
k
l
1 0500-7472-01
1 2402-1254-01
1 5801-3051-120
1 0500-7485-01
1 0500-7488-01
1 0500-7719-01
2 5801-2061-120
2 5826-0200-020
3 2880-0011
3 2880-0073-01
3 5842-0300-020
3 5810-4091-120
d
c
a
i
SPEEDDOME ULTRA
INDOOR DOME INSTALLATION
Procedure
Referring to Figure 2-12:
1. Insert wall mount bracket [d] into the corner
bracket [a] until it snaps in place. Secure
brace of wall mount bracket using M5x8
screw [c]
2. Cut arm [e] to length and slip cap [f] over it.
3. Insert the arm into the wall mount bracket
and secure using two M4x10 screws [g].
4. Place arm assembly on wall, level, and mark
mounting hole locations.
5. Anchor by performing step 2a, 2b, or 2c.
a. To sheet rock: Use anchor [j], washer [k], and
screw [l].
b. To wood: Use washer [k], and screw [l].
c. To concrete: Use anchor hardware [i].
6. Apply self-adhesive label applique [b] over
access slots in corner bracket.
7. Attach the base or top hat housing by per-
forming step 7a or 7b.
a. Direct base attachment. Attach the dome's base
to the flange of the arm using two M3 locking nuts
[h]. Feed cables as shown.
b. Top hat housing attachment. See "Top Hat Hous-
ing", page 2-5.
8. Go to "Dome Setup and Attachment", page
2-17.
g
e
b
2-13
f
Base
h