Installation Checklist; Installation; Commissioning - Seeley Climate Wizard CW-H10 Installation & Operation Manual

INSTALLATION CHECKLIST

Owner Name: .............................................................................
Address: .....................................................................................
......................................................................................................
Dealer: ..............................................................
Date Installed: ..................................................
Serial No: ..........................................................

INSTALLATION

□ The cooler is adequately supported, secure and level.
□ The water pipes were flushed of any foreign materials before connection the cooler was made.
□ The owner has been instructed on how to isolate the water to the system in case of emergency.
□ Water pressure reducing valve fitted if required.
□ The water is connected with no leaks at fittings.
□ Water pipes are correctly saddled as per the applicable plumbing regulations.
□ The drain water does not discharge onto the roof surface.
□ The power supply adheres to all local and national regulations and is wired back to the distribution board on its own separate
circuit.
□ All cables have been correctly connected to the control boxes (i.e. power supply, control cable)
□ The owner has been instructed how they can electrically isolate the cooler at the meter box in case of an emergency.
□ All ducts are fixed correctly and there are no air leaks.
□ The air balance for all outlets has been adjusted to the customer's satisfaction.
□ The customer has been shown how to operate the system.
□ All the installation rubbish has been removed and, if applicable, any property damage repaired.

COMMISSIONING

□ Inlet filter installed correct way round. Observe Airflow direction arrows.
□ Cooler internal water levels checked. No water draining from overflow
□ Chlorinator fully submerged at low water level.
□ Exhaust Cap fitted - refer page 13. (CW-H15S Plus Only)
□ Air flow balancing set discharge damper (refer page 21). Value = _______________kPa
□ DEVICE TYPE set on PLC, refer "CW-H CONTROL SCHEMES" on page 17 (CW-H15S Only)
□ Unique NODE ADDRESS set for each cooler, see "WALL CONTROLLER / RS-485 MODBUS NODE ADDRESS" on page 18
(multiple cooler installations only)
□ 120Ω resistor fitted to Wall Control and last Cooler.
□ PLC Control Option LCL / W/C / BMS (circle applicable).
Signed by Installer: .........................................
Dated: ...............................................................
22 |
CW-H10, H15, H15S, H15S Plus 859749-A
Telephone: ........................................................
Installer: ............................................................
Model No: .........................................................
Commissioning Engineer: ..............................
Date: ..................................................................