Advertisement
Start the Bookcase assembly by using either one of the Bookcase End Panels and fixing it to the
Back Panel. Ensure the cam locks on the Back Panel are not facing what will be the inside of the
Back Panel - Place the Bookcase Back Panel onto the End Panel. Match up the cam locks with the
cam pins. Tighten the cam locks and cam pins together by using a Phillips head hand screwdriver.
Top & Bottom Panels - With the cam locks facing away from the inside of the Bookcase attach the
Bottom Panel to the End Panel and Back Panel. Repeat this process with the Top Panel. Refer to
images 1 & 2 on page 4
Place the remaining End Panel on top of the previously assembled panels. Ensuring the cam pins
are lined up with the cam locks. Tighten the cam pins to the cam locks.
Tip: You may need to lightly tap the cam pins into the cam locks with a rubber mallet. Ensure you
do this where the cam pins are. Failure to do so may result in damage to the End Panel.
You will need to pre-drill the 5mm screw holes. When attaching the cabinet to the wall bed.
• Temporarily fasten the cabinets together with clamps. Pre-drill a total of four 5mm pilot holes
in the end panel of the cabinet — two towards the top of the unit and two at the bottom.
IMPORTANT – When pre-drilling wood screw pilot holes use caution not to go all the way
through to the end panel of the wall bed.
• Attach the cabinet to the wall bed using the 28mm screws supplied. Then remove the
clamps.
Caution: Do Not over tighten the wood screws into the side of the cabinet End Panel as it may
end up protruding through the opposite side of the panel.
Adjustable Shelf - Insert the shelf pins into the shelf pin holes at the desired height for your shelf.
If you find it too high or too low for the books you want to store, relocate the shelf pins to the
holes at the required height.
All WallBeds Australia Bookcases and Cabinets must be securely attached to the WallBed before
use. Ensure that children DO NOT climb or hang on any part of the Bookcase Or Cabinet. Failure
©2019 WallBeds Australia
Step 2 - Bookcase Assembly
Bookcase when built.
Step 3 - Fixing Bookcase to the Wall Bed
These holes will be covered using the FastCaps supplied.
IMPORTANT SAFETY INFORMATION
to do so may result in personal injury.
3
Advertisement
