Huawei UPS2000-G-6 kVA User Manual page 25

UPS2000-G-(6 kVA-20 kVA)
User Manual
Compone
nt
batteries)
Standard
battery pack
(9 Ah, 20
batteries)
Modbus
card
Dry contact
card
External dry
contact card
iBAT 2.0
Issue 13 (2019-05-05)
Model
ESS-240V12-9AhBPVBA01
ESS-240V12-9AhBPVBA02
RMS-MODBUS01A
RMS-RELAY01A
RMS-RELAY02B
N/A
Copyright © Huawei Technologies Co., Ltd.
Function
connected in series. It is
a standard configuration
for the UPS2000-G-6
kVA. A maximum of
four battery packs are
connected in parallel.
Each battery pack
consists of twenty 12 V,
9 Ah VRLA batteries
connected in series. It is
a standard configuration
for the UPS2000-G-10
kVA. A maximum of
four battery packs are
connected in parallel.
Provides two cascaded
RJ45 ports to
implement networking
over the Modbus or
YDN-23 protocol.
Provides six alarm dry
contact outputs (normal
mode, battery mode,
bypass mode, low
battery voltage, bypass
backfeed, and UPS
faults) and two dry
contract control inputs
(one is the shutdown
signal input, and the
other is reserved).
Provides four dry
contact outputs (critical
alarm, minor alarm,
mains mode, battery
mode, bypass mode,
inverter on, battery
undervolt., bypass
backfeed, high ambient
tempreture, or UPS
fault.) and two dry
contract inputs (startup,
shutdown).
Consists of the
communication
interface module (CIM)
and battery interface
module (BIM). The
CIM is an intelligent
2 Quick Introduction
Remarks
uses at least two
battery packs.
N/A
N/A
Used together
with an SNMP
card.
Used together
with an SNMP
card.
17