Setting Up From A Client Computer; About Configure - Xerox EX 570 Configuration And Setup

S
ETTING UP FROM A

About Configure

T
O ACCESS
S C
ETTING UP FROM A
C C
LIENT OMPUTER
After you start the EX/i Print Server for the first time, or install system software, you must set
up the EX/i Print Server. If you do not, default settings are used. Make sure that settings are
appropriate for your printing environment. If your network or printing environment changes,
you may need to adjust your settings.
Set up from the printer touch panel
Perform initial Setup from the printer touch panel (see
change options from a client computer.
Set up from a client computer
After you perform initial Setup from the printer touch panel, you can change most options
from a client computer using Configure.
If you are setting up the EX/i Print Server for the first time, you can use the Fiery Setup
Wizard to configure language, regional, server, and print environment settings. For more
information, see page 32.
You can find more information about using Configure the following ways:
• If you access Configure from an Internet browser, in WebTools, on the Configure tab,
click the Help icon.
• If you access Configure from Command WorkStation, see Command WorkStation Help.
C I
ONFIGURE FROM AN NTERNET BROWSER
1 Open an Internet browser and type the IP address of the EX/i Print Server.
2 In WebTools, on the Configure tab, click Launch Configure.
3 Log on with Administrator privileges.
C
LIENT OMPUTER
page 25). After initial Setup, you can
31