Operation; Bluetooth Mode; Aux Mode - Krüger & Matz DISCOVERY LITE Owner's Manual

OPERATION

Turning on/off
Press and hold the Power button for about 3 seconds to turn on the speaker (the device
will issue a sound and blue LED indicator will turn on). Press and hold the same button for
about 3 seconds to turn off the speaker (LED indicator goes off). Press and hold for about
10 seconds to reset the speaker.
Answering/rejecting/ending a call
Press the Multifunctional button to answer an incoming call. Press the same button to end
a call. Press and hold to reject a call.
Note: Make sure to remain within 1 meter from the microphone while speaking.
Play/pause music
While playing music, press the Multifunctional button to play/pause music.
Volume adjustment
Press the – button to decrease volume (each press decreases volume by one level).
Press the + button to increase volume (each press increases volume by one level). When
volume is increased to the maximum, you will hear a voice prompt.
Track selection
Press and hold the – button to go to the previous track. Press and hold the + to go to the
next track.
8

BLUETOOTH MODE

Pairing:
1. Make sure the speaker is turned on.
2. Press and hold the Multifunctional button for about 2 seconds to enter Bluetooth pairing
mode; the speaker will issue a voice prompt and the LED indicator will flash blue quickly.
3. Please keep the speaker and external device close to each other when pairing.
4. Enable Bluetooth function on the external device and search for new Bluetooth devices.
5. Select and connect with this device (KM Discovery Lite). Enter password "0000" if necessary.
6. The speaker will issue a voice prompt signifying a successful pairing; LED indicator will flash
blue slowly.
Notes:
• If pairing is not completed within 2 minutes, the speaker will quit the pairing mode. In
that case, repeat pairing process to pair the speaker with external device.
• When there is no operation in Bluetooth mode within 20 minutes, the speaker will turn
off automatically to save power.
• Every time the speaker is switched on, it will connect to last connected device
automatically. Please note, your device must be on with Bluetooth function turned on.

AUX MODE

1. Use the included 3,5 mm jack cable and connect one plug of the cable to the speaker's
AUX input. The speaker will switch to AUX mode automatically and the green LED indicator
will be on.
2. Connect the other plug into the 3,5 mm output of the external device you wish to play
music from.
Owner's manual