Connecting The Machine - VERITAS Claire Instruction Manual

Connecting the machine

Attention:
Always make sure that the machine
is unplugged from power source and
the main switch is on ("O") when the
machine is not in use and before
inserting or removing parts.
Before connecting the power supply,
make sure that the voltage and the
frequency shown on the rating plate
conform to your mains power. Place the
machine on a stable table.
1. Connect the machine to a power
source as illustrated.
ON
2. Turn on the power switch.
3. The sewing lamp will light up when
the switch is turned on.
OFF
Foot control
With the sewing machine turned off,
insert the foot control plug into its
connector on the sewing machine.
Turn on the sewing machine and then
slowly depress the foot control to start
sewing. Release the foot control to stop
the sewing machine.
Note:
Consult a qualified electrician if in doubt
about how to connect the machine to
the power source.
8