Zipper Insertion; Inserting A Centered Zipper - VERITAS Claire Instruction Manual

Zipper insertion

This foot can be set to sew on each side of the zipper, the edge of the foot guides
the zipper to ensure straight placement.
00
1.0~3.0
2
3
4
5
1
3.5
4
5
Attention:
Zipper foot should be used for sewing
straight stitches only. It is possible that
the needle hits the presser foot and
breaks when sewing other patterns.

Inserting a centered zipper

- Place the right sides of the fabric
together. Sew a bottom seam 2cm
from the right edge of the zipper
bottom stop position. Sew a few
stitches in reverse to lock. Increase
the stitch length to maximum, set
the tension below 2 and baste the
remaining length of the fabric.
- Press open the seam allowance.
Place the zipper face down on
the seam allowance with the teeth
against the seam line. Baste the
zipper tape.
2cm
1
2 5mm
Reverse stitches
3
Basting stitching
4
Reverse side
5
- Attach the zipper foot. Attach the
right side of the presser foot pin to
the holder when sewing the left side
of the zipper.
- Attach the left side of the presser foot
pin to the presser foot holder when
sewing the right side of the zipper.
54