Fuel Strainer - Navistar MaxxForce DT Operation And Maintenance Manual

Hide thumbs Also See for MaxxForce DT:
Table of Contents

Advertisement

SECTION 5 – MAINTENANCE SCHEDULE AND SERVICE PROCEDURES
21. Wait for the WAIT TO START lamp to stop illuminating.
Do not crank engine until the lamp is off. When the WAIT
TO START lamp goes off, turn ignition switch to START. If
the vehicle has push button starting, press and hold starter
button.
22. When the engine starts, release the ignition switch or starter
button. The ignition switch will return to ON and the engine
will continue to run. Check for leaks. Turn the ignition switch
to OFF.

FUEL STRAINER

Service Interval: 30,000 miles (43,300 km), 12 months, 1,100
hours or 15898 liters (4200 gallons) of fuel
NOTE: If fuel used has more than average impurities,
shorter service intervals may be required.
NOTE: The fuel strainer is located under the electric fuel
pump. The pump must be disconnected from the engine
wiring harness and removed from the fuel filter housing for
the fuel strainer to be cleaned or replaced. See following
procedure.
WARNING
To prevent personal injury or death, do not smoke
and keep fuel away from flames and sparks.
Figure 39 Electric fuel pump and fuel strainer location
1.
Electrical fuel pump wiring harness connector
2.
Fuel filter cap
3.
Fuel filter housing
Page 79

Advertisement

Table of Contents
loading

This manual is also suitable for:

Maxxforce 9Maxxforce 10

Table of Contents