Service Procedures; Oil Level - Navistar MaxxForce DT Operation And Maintenance Manual

Hide thumbs Also See for MaxxForce DT:
Table of Contents

Advertisement

SECTION 5 – MAINTENANCE SCHEDULE AND SERVICE PROCEDURES

Service Procedures

GOVERNMENT REGULATION: Engine fluids
(oil, fuel, and coolant) may be a hazard to human
health and the environment.
and other contaminated materials (such as filters,
rags) in accordance with applicable regulations.
Recycle or dispose of engine fluids, filters, and
other contaminated materials according to applicable
regulations.
WARNING
To prevent personal injury or death, shift
transmission to park or neutral, set parking
brake, and install wheel chocks before doing
diagnostic or service procedures.

OIL LEVEL

Service Interval: Before Engine Operation
1. Park vehicle on level ground.
Page 60
Handle all fluids
NOTE: Do not check oil level if engine is running or
immediately after engine shutdown.
2. Shut down engine and wait 15 minutes.
3. Remove oil level gauge from fill tube.
Figure 27 Oil level gauge (typical)
CAUTION
To prevent engine damage do the following:
Assure oil level readings are within the
crosshatched operating range on the oil level
gauge.
Do not overfill the engine with oil.
Do not operate engine if oil level is above or
below the operating range.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Maxxforce 9Maxxforce 10

Table of Contents