2.7 Installing the Outdoor Unit
The outdoor unit can be secured to the pole using one of the following options:
Special brackets sets (supplied with each unit). There are two pairs of screw
holes on the units, allowing the use of the brackets with various pole widths.
U-bolts - size A (inner installation holes, up to 2" pole)
U-bolt - size B (outside installation holes, up to 3" pole)
Metal bands (9/16" wide, minimum 12" long)
Figure 2-2 shows the locations of the holes, grooves and screw holes on the rear
side of the unit.
Figure 2-3 illustrates the method of installing an unit on a pole using the supplied
brackets.
Note:
BreezeNET BU-DS.11/RB-DS.11
Make sure to install the unit with the bottom panel (the panel with the signal
strength bar and LEDs) facing downward.
Grooves for Insertion of 9/16" Metal Band
Figure 2-2. Holes/Grooves/Screw Holes
Size B U-Bolt Holes (3" Pole)
Size A U-Bolt
Holes (2" Pole)
Bracket Screw Holes
2-13
Installation
User's Guide