Replacing The Audio Module With Programming Restore Backup - Comelit Simplebus1 UT1010 Technical Manual

Replacing the audio module with programming restore
backup
If the audio or audio/video module is replaced, the following instructions must be observed.
The procedure should be completed within one hour of removal of the old module.
1
1
OLD
3
S1 S2
1
5
S1 S2
6
3
1
2
2
Take note of the DIP-switch
settings
1
2
ON
1 2 3 4 5 6 7 8
cod. 114
3
1
3
2
2
1. Enter programming mode by moving S2 DIP-switch
upwards
» the red "system busy" LED
the procedure
2. Set special programming 114 to import all the
programming settings
3. Press the confirm programming button
» the green "lock-release" LED
» at the end of the backup (approx. 30 sec.):
» the green "lock-release" LED
» the green "audio enabled" LED
few seconds.
2 1. Exit programming mode by moving the S2 DIP-switch
downwards
» the red "system busy" LED
2. Reset the configuration of the DIP-switches
3. Reattach the front panel
3
4
NEW
3
4
flashes for the duration of
will start flashing
switches off
comes on for a
switches off
5
1
2
27