Comelit Simplebus1 UT1010 Technical Manual page 22

243 1,2,5,6,7.8
244 3,5,6,7,8
208 5,7,8
209 1,5,7,8
249 1,4,5,6,7.8
250 2,4,5,6,7.8
142 2,3,4,8
143 1,2,3,4,8
158 2,3,4,5,8
159 1,2,3,4,5.8
160 6.8
161 1,6,8
162 2,6,8
163 1,2,6,8
150 2,3,5,8
151 1,2,3,5,8
152 4,5,8
114 2,5,6,7
115 1,2,5,6,7
254 2,3,4,5,6,7,8
22
Reset wait time (after hang-up or after lock-release): 10 sec (default)
Reset wait time (after hang-up or after lock-release): 1 sec
Enables "Reset wait time" on lock-release command (default)
Disables "awaiting reset time" on lock-release command (awaiting response time or talk time will be
activated)ù
Send call: single (default)
Call transmission: triple
Button tones
Button press tone ON (default)
Button press tone OFF
Button backlighting management
OFF mode: Button LEDs always off
ON mode: Button LEDs always on
AUTO mode: Button LEDs on at night and off during the day, thanks to the twilight sensor (default)
Enables brightness control for the button LEDs.
f Press a button repeatedly for each module to change the individual brightness of the buttons
(see: "Adjusting the brightness of the button
Light-me OFF (default)
Light-me ON: the button LEDs for the audio/video module are always on and when the button is
pressed all button LEDs light up (see:
backlighting mode")
Light-me time: 30 sec
Light-me time: 60 sec (default)
Light-me time: 120 sec
Restore backup
If the audio/video module is replaced, all programming is imported (only available if at least one
additional module is connected vi flat cable)
Reset
Reset button programming: if the modules are addressed (see
resets the programming for the button call addresses
Reset special programming: restore all the parameters described in this table to their default values
LEDs")
"Light-me function behaviour on the basis of the LED
"Address button modules") this