Mitsubishi MELSEC-A Series Programming Manual page 373

9. ERROR CODE LIST
Error
Error Message Code
(D9008)
13
"CAN'T
EXECUTE(P)"
"CHK FORMAT 14
ERR"
"CAN'T 15
EXECUTE (I)"
Table 9.2 Error Code List for AnSHCPU (Continue)
Detailed
Error CPU
Code States
(D9092)
— Stop (1) There is no jump destination or
multiple destinations specified by
the
JMP
(2) Although there is no
instruction, the
exists in the program and has been
executed.
(3) The
JMP
with its jump destination located
below the
(4) The number of the
is different from that of the
instructions.
(5) A
FOR
processing to exit the loop.
(6) Processing exited subroutine by the
JMP
the
(7) Processing jumped into a step in a
FOR
subroutine by the
— Stop (1) Instructions (including
LD X , LDI X , AND X
X
instruction circuit block.
(2) Multiple
(3) The number of contact points in the
CHK
exceeds 150.
(4) The device number of X in the
instruction circuit block exceeds
X7FE.
(5) There is no
before the
block.
(6) The device number of D1 of the
CHK D1D2
from that of the contact point before
the
(7) Pointer P254 is not given to the
head of the
block.
P254
— Stop (1) Although the interrupt module is
used, there is no number of interrupt
pointer I, which corresponds to that
module, in the program or there are
multiple numbers.
(2) No
entered in the interrupt program.
(3) There is
than the interrupt program.
Error and Cause
, , , , or
CJ SCJ CALL CALLP
instruction.
CALL
instruction
RET
, , , , or
CJ SCJ CALL CALLP
instruction has been executed
instruction.
END
instructions
FOR
NEXT
instruction is given within a
JMP
to loop causing the
NEXT
instruction before execution of
instruction.
RET
to loop or into a
NEXT
instruction.
JMP
) except
NOP
and ANI
are included in the
CHK
instructions are given.
CHK
instruction circuit block
CHK
circuit block
CJ P
instruction circuit
CHK
instruction is different
instruction.
CJ P
instruction circuit
CHK
CHK D1D2
instruction has been
IRET
instruction in other
IRET
9 - 7
Corrective Action
Read the error step by use of peripheral
equipment and correct the program at
that step.
(Insert a jump destination or reduce
multiple destinations to one.)
(1) Check the program in the
instruction circuit block according to
item (1) to (7) in the left column.
Correct problem using the peripheral
equipment and perform operation
again.
(2) This error code is only effective
when the input/output control
method is a direct method.
(1) Check for the presence of interrupt
program which corresponds to the
interrupt unit, create the interrupt
program, and reduce the same
numbers of I.
(2) Check if there is instruction in
IRET
the interrupt program and enter the
instruction.
IRET
(3) Check if there is instruction in
IRET
other than the interrupt program and
delete the instruction.
IRET
CHK