Installation Procedure; Installing The Ceiling Tile Drop-In Speaker - CyberData 011401 Installation Quick Reference

Installation Procedure

To install the Ceiling Tile Drop-In Speaker, complete the following steps while referencing the figure below:
1. Remove the Ceiling Tile (Showing a 2 x 2 Grid) from the Ceiling Grid then Cut it in Half.
2. Place the Cross T in the Middle to Support the Weak Side of the Ceiling Tile.
3. Replace the Ceiling Tile on to the Ceiling Grid.
4. Use a Flat Blade Screwdriver to Pry Up the Seismic Tether Bracket(s) on the 1 x 2 Ceiling Tile Speaker
Assembly.
5. Install Eyebolt(s) or Nail(s) to the Joist.
6. Connect the Network Cable to the Network Port and Wire(s) to the Terminal Block, etc. to the 1 x 2 Ceiling Tile
Speaker Assembly.
7. Use Steel Wire(s) to Connect Seismic Tether Bracket(s) to the Eyebolt(s) or Nail(s). Place the 1 x 2 Ceiling Tile
Speaker Assembly on to the Ceiling Grid and the Cross T.

Installing the Ceiling Tile Drop-In Speaker

Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
© 2019, CyberData Corporation, ALL RIGHTS RESERVED.
Joist
6
4
*
*
*
8
931262D
Eyebolt / Nail
5
7
Steel Wire
*
*
Cross T
1, 3
1 x 2 Ceiling Tile
Speaker Assembly
2
2 x 2 Ceiling Tile
Quick Reference