Table of Contents
Advertisement
3C—Wall Mount with Bracket
NOTE: The mounting location must be able to support the weight of the AP and the mounting bracket (about 2 lb. total).
1.
If the mounting plate is attached to the AP, remove it (push it against the
AP and twist it to the left). Align the three holes in the wall bracket
(ordered separately, see page 2) over the corresponding mounting plate
holes, indicated in the photo. The wall bracket's small locking tab should
point down toward the mounting plate.
NOTE: Use only the screws provided in the accessory kit. Other screws that seem
equivalent in size may damage the mounting plate.
2.
Use the three screws provided in the accessory kit to attach the wall
mount bracket to the AP mounting plate.
3.
Use the Wall Mount Bracket as a template and mark the locations on the
wall for the mounting holes. The bracket must be secured to the wall in 3
places. When marking the holes, make sure the mounting plate is level.
The bracket is normally oriented so that the mounting plate and AP are
suspended beneath it.
4.
Attach the mounting plate to the wall with 3 user-supplied screws appropriate to the wall construction type.
5.
Cut an access hole for the cable(s) in the wall and draw enough cable through to attach to the AP after it is
installed.
6.
Proceed to "Connect Cables and Install AP" on page 4.
4
Connect Cables and Install AP
NOTE: Once you connect the AP's GIG1/POE port, an automatic upgrade typically starts soon after the AP has Internet
connectivity. Do not unplug this port while booting or during the upgrade process or the AP may become inoperable.
The upgrade should take 10 minutes or less depending on bandwidth.
1.
(Optional) For a locked installation, insert the provided locking slug
into the slot on the back of the XD2-230, to the left of the RESET
button (see photo on
on the locking slug—it should face toward the RESET button.
Connect the cable that carries power and data to GIGABIT1/POE+
2.
(shown in red). If you use a Cambium Xirrus-supplied injector, its
CONNECT LED should light (for 70W and higher injectors, it is OK if
it blinks). If power is being properly supplied, the AP's LEDs will
light and then commence blinking in their rotating boot pattern. A
second data connection may be plugged into GIG2 (optional).
XD2-230 Installation Guide
page
6). Note the orientation of the slight bump
4
Advertisement
Table of Contents
