Connector Board Cable - HP EliteBook x360 1030 G8 Maintenance And Service Manual

4. If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve must be
installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.

Connector board cable

To remove the connector board cable, use this procedure and illustration.
NOTE: The connector board cable is available in the Cable Kit, spare part number M20833-001.
Before removing the connector board cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board the battery (see
Remove the connector board cable:
1. Disconnect the cable from the ZIF connector on the system board (1).
2. Disconnect the cable from the ZIF connector on the connector board (2).
Preparation for disassembly on page
Bottom cover on page 35).
35).
Battery on page 36).
Component replacement procedures 41